Full transparency, we don’t 100% know! Is that a crazy thing for a brand to say? Cool, we are happy to be the first. We developed a new “system” that combines fabrics with different care instructions. While 3L fabric requires heat to activate the DWR and frequent washing to remove dirt and grime that compromises membrane and DWR, frequent washing and heat damages coatings and it is not necessary for performance.
Our design ethos stipulates everything we do is a work in progress.
The best way forward is to understand and adapt a washing system that works for you and the fabric. You can always reach out to us for advise.
Wash Frequency
These instructions are written under the assumption that you are not ski touring in these products which limits sweat build up. Wash once a season or as needed. We believe best practice is to do it at the end to get rid of the sweat and grime before storing them for the summer. Washing inside out will be more effective in cleaning the interior.
Too much washing results in excessive agitation and unnecessary wrinkling, which is bad for the coating. While not washing leaves dirt and grime on the inside that can also compromise the coating bond. Since there is limited DWR and less sensitive membrane in areas with sweat builds up, washing and drying is not as necessary for durability and efficacy. Additionally, our coating is exterior, so dirt is easy to wipe off and sweating is limited when riding chairlifts.
Washing
Wash with cold water (we also like the eco warm setting for a better wash) on a gentle cycle or hand wash. While we have not proven effeficay or impact, we often will wash them inside out to remove dirt from the inside. Because the coating does not have holes, washing right side out prevent water from reaching the inside.
Detergent
Use gentle, fragrance-free, and no-additives detergent. This means no softeners, no fancy stain removers, etc. Do not use powder detergent. Do not use bleach or fabric softener. I will often forgo detergent when washing my coated products and opt for eco warm cycle with product inside out.
Drying
It is best to dry flat, not machine dry, as the coated fabric does not do well with heat and reactivating DWR is not as important. Drying flat (versus hanging) prevents the misshaping of softshell fabric.
Note: Typically, we dry out outerwear to reactivate DWR. On our products membrane fabrics live in lower pressure locations and DWR efficacy is not as important.
Dry both inside out and right side out. Make sure the inside and the outside dry! Because the coated fabric is not breathable, the inside will not dry as well as other ski pants. Select a minimally sunny location for drying, as excessive and reoccuring sunlight can damage the coating.
Reactivate DWR
This is not necessary as high pressure areas are not prone to wetting out. Hang dry, then once dry or almost dry, machine dry on low heat. I use the ‘time dry’ setting for 20 minutes right side out. You can test the DWR on the 3L fabric by dropping some water on it. If the water beads, the DWR is re-activated. If the water soaks in, dry bibs on low heat, right side out again for 10 minutes. Repeat until water beads. If you have done this several times with no beading, you must re-apply the DWR. I recommend using a DWR spray to target the 3L panels.
Storage: Store them on a hanger, folded at the middle and draped (not hanging by the straps) — try not to bunch or jam into a box or bag. Hanging them by the straps stretches the softshell upper. Jamming and wrinkling compromises the coating.